Printer Settings
Phaser® 6300/6350 Color Laser Printer
5-5
Using CentreWare IS
To select the Tray 1 (MPT) prompt timeout using CentreWare IS:
1. Launch your web browser.
2. Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the General folder on the left sidebar, and then select Printer Defaults.
5. Select the appropriate prompt setting in the Tray 1 (MPT) Prompt drop-dowm list.
6. Click the Save Changes button at the bottom of the page.
Setting the Duration for Tray 2 - 5 Prompts
The Tray 2 - 5 prompt setting specifies the amount of time the prompt displays on the control
panel after paper is loaded in Trays 2 - 5. The Tray 2 - 5 Prompt asks the person that loaded the
paper to confirm the current tray setup or to specify the paper type.
To select a Tray 2 - 5 prompt timeout, use either:
■ The printer’s control panel
■ CentreWare IS
Using the Control Panel
To change the Tray 2 - 5 prompt timeout on the control panel:
1. Select Paper Tray Setup, and then press the OK button.
2. Select Paper Handling Setup, and then press the OK button.
3. Select Tray 2 - 5 Prompt, and then press the OK button.
4. Select the appropriate prompt setting, and then press the OK button.
Using CentreWare IS
To select the Tray 2 - 5 prompt timeout using CentreWare IS:
1. Launch your web browser.
2. Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select General on the left sidebar, and then select Printer Defaults.
5. Select the appropriate prompt setting in the Tray 2 - 5 Prompt drop-dowm list.
6. Click the Save Changes button at the bottom of the page.
Setting Behavior
None
(Default)
Turns the tray setup prompt off.
30 seconds Displays the tray setup prompt for 30 seconds after loading paper in Trays 2 - 5.
Infinite Displays the tray setup prompt after paper is loaded in Trays 2 - 5 until a control panel
selection is made.
To Next Page
Loading...
