Overview
Xerox WorkCentre 3315DN/3325DN/3325DNI
System Administrator Guide
70
Overview
The user scans a document at the machine and it is stored on a file server or workstation on the
network. The user can manually retrieve their document from the file server or workstation, or an
application can be used to retrieve the scanned documents automatically.
The instructions on the following pages describe how to setup Scan to Server using Internet Services.
Information Checklist
Before starting please ensure that the following items are available and/or the tasks have been
performed:
• Ensure that the machine is fully functioning on the network.
• TCP/IP and HTTP protocols must be enabled on the machine so that the machine’s web browser
can be accessed.
Scan Transfer Methods
Scan to Server is accomplished through the use of a folder on a server or workstation, which the
machine can access. When a user scans a document, the machine puts the image into the folder. To
configure Scan to Server you must configure the machine with the path to the folder.
The machine can use two different ways to transfer a scanned image to the folder:
• FTP (File Transfer Protocol) - refer to Configure Scan to FTP on page 71.
This is used to scan to a computer that is configured with FTP services.
• SMB (Server Message Block) - refer to Configure Scan to SMB on page 74.
This is used to scan to a computer that supports the SMB protocol.
To Next Page
Loading...
Need help?
General
