Network Connectivity
Xerox
®
WorkCentre
®
4265 Multifunction Printer 45
System Administrator Guide
Connecting to a Wireless Network Manually
When connecting to a wireless network that does not include a WPS-compliant router, set up and
configure the printer manually. Before starting, you must get the setup and configuration information,
such as name and passphrase, from the router. After you collect the network information, you can set up
the printer from the control panel or from CentreWare Internet Services. For the easiest manual
connection, use CentreWare Internet Services.
Before you begin:
• The wireless router must be connected and properly configured for the network before you install
the printer. For details, see your router documentation.
• Use the instructions provided with your wireless router or access point to record the following
information:
− Name (SSID)
− Security Options (Encryption Type)
− Passphrase
Note: The network name and passphrase are case sensitive.
Configuring the Printer for Wireless LAN WPA-Enterprise
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols.
2. Click Wireless Setup.
3. Click Edit Settings.
4. For Network Name SSID, select an option.
5. To refresh the list of available networks, click Refresh.
6. For Security Type, select WPA/WPA2-Enterprise.
7. For 802.1x Authentication, select an authentication protocol.
− If you select EAP-TTLS, select an Inner Authentication Protocol, then type an Identity Name,
User Name, and User Password.
− If you select PEAP, type a User Name and Password.
8. For Root Certificate Setup, upload a Root Certificate.
9. For Client Certificate Setup, upload a Client Certificate, then enter the Private Key Password.
10. For Address Acquisition, select a protocol option.
11. Click Apply.
To Next Page
Loading...
Need help?
General
