Need help?Do you have a question about the Xilinx FMC XM105 and is the answer not in the manual?
General| Power Supply | +3.3V, +12V |
|---|---|
| Form Factor | FMC (FPGA Mezzanine Card) |
| Connector Type | High Pin Count (HPC) connector |
| Supported Standards | VITA 57.1 |
| Size | Standard FMC module size |
| Dimensions | 76.5mm x 69mm |
| Operating Temperature | 0°C to +70°C (Commercial) |
| Compatibility | Compatible with Xilinx FPGA development boards supporting FMC interface |
This document describes the FMC XM105 debug card and its related boards.
Links to find additional Xilinx documentation and technical support resources online.
Introduces the FMC XM105 debug card and its companion boards.
Lists essential Xilinx resources and documentation for using the XM105.
Provides essential steps for setting up and using the XM105 debug card.
Details the hardware and software prerequisites for the XM105.
Lists the items included in the HW-FMC-XM105-G shipment.
Specifies the tools and resources required for XM105 installation and setup.
Step-by-step instructions for installing the XM105 onto a Xilinx board.
Information on obtaining technical support for the XM105 and Xilinx boards.
Visual representation of the XM105 connectors and interfaces.
Details the pin assignments and connections for the FMC HPC connector J17.
Explains the configuration of the 6-pin header for voltage settings.
Describes the JTAG interface connections via connector J5.
Details the 16-position connector J20 and its signal assignments.
Explains the 12-position connector J23 and its signal assignments.
Details the 12-position connector J16 and its signal assignments.
Describes the 6-position connector J15 and its connections to user LEDs.
Information on the four user LEDs and their active-high signal indication.
Details the 40-position connector J2 and its signal assignments.
Explains the 40-position connector J1 and its signal assignments.
Details the 40-position connector J3 and its signal assignments.
Describes the 38-position Mictor connector P1 and its signal assignments.
Explains the 9-position connector J19 and its connection to Mictor P1.
Details the clock sources, SMA connectors, and Si570 component.
Information on the M24C02 2-Kb serial IIC bus EEPROM for non-volatile storage.
Describes the three power good LEDs and their indicators.
Explains the 2x1 connector J18 for signaling power status.
To Next Page