ipVG Product Guide HeiTel by Xtralis
12 29794_00
3.3 Mounting and Setting up
ipVG is designed for use in specific ambient conditions. Conditions deviating from these can cause damage to
the device, or to the recorded data. Warranty will be voided in this case. Please maintain the ambient
conditions described below when using your ipVG device.
3.3.1 General Safety Information
l Make sure to carefully read and understand this guide before operating the device.
l Do not expose the device to strong vibration or shock.
l Avoid humidity or dust, extreme temperature fluctuations, or strong magnetic fields.
l The operating temperature for ipVG is between +5°C and +40°C.
l Provide sufficient ventilation. Do not block vents. Provide sufficient air circulation for cupboard
installations.
l Never expose the device to direct sunlight. Keep it well away from other sources of heat (radiators, etc).
l Installation orientation: vertical, horizontal with a deviation of max. ±5° with use of the joint mounting kit
for ipVG.
l It is essential that you maintain the required ambient conditions for outdoor installations. Protect the
device against atmospheric influence.
l Wait at least 10 seconds after switching off the device before turning it on again.
l Select an installation site protected against burglary and vandalism. Ensure unrestricted ventilation.
l Make sure that specification limits are not exceeded when connecting external devices.
3.3.2 Electrical Safety
l Always make sure that your hands are completely dry before touching ipVG, the power supply unit,
cables, or sockets. Never touch these with wet hands.
l Disconnect the device from the power supply by pulling at the plug, not at the cable. Never pull at the
cable.
l If water or any other liquid enters the device, immediately disconnect the power supply. Have the device
checked by customer service.
l The device contains no components that can be adjusted or repaired by the user. The device housing
must never be opened.
To Next Page
Loading...
General