HeiTel by Xtralis ipVG Product Guide
29794_00 13
3.4 System Environment
3.4.1 Overview of Software for Operation, Alarm Verification, and
Configuration
ipVG is a standalone unit. Once installed and configured, it reacts to events, records these on a continuous or
on an event-triggered basis, transmits and/or saves video and/or audio data, alarms to local and remote
receiver units, and additionally logs protocols locally. Only one of the following software packets, developed
by HeiTel especially for CCTV applications, is required for the PC based receiver/evaluation unit.
l CamControl LITE (part of ipVG delivery) software for operation, alarm verification, and configuration for
single workstations with up to 6000 transmitters CamServer, Cam4mobile, CamDisc, CamTel and/or
CamDisc HNVR. The CamControl LITE software is used for setting up the ipVG.
l CamControl PRO software for operating, alarm verification and configuration of single workstation
applications. Enables simultaneous viewing of up to 21 transmitters. Maximum 6000 transmitters
(CamServer, Cam4mobile, CamDisc, CamTel and/or CamDisc HNVR).
l CamControl PLAYER (included in ipVG delivery) software for replay and evaluation of CamServer,
Cam4mobile, CamDisc and PC archives, and integral part of CamControl LITE and CamControl PRO.
Note: Information on other software solutions, in particular for integration into higher-level control centres
such as HeiTel's Event Management System (EMS) or the video wall software CamControl MV, is
available on request.
3.4.2 Compatibility of Software Versions
Ensure compatibility of CamControl software with your ipVG. The table below provides an overview:
Software Compatible from version
CamControl LITE 4.53
CamControl PRO 4.41
CamControl PLAYER 3.69
PC requirements
Please refer to the appropriate CamControl software guide for PC hardware and software requirements.
To Next Page
Loading...
General