– 37 –
• Use of the ECU in the kit and the harness allows functioning of the following codes in the
STD diagnosis.
* YMS-Monitor: YEC FI Matching System also allows functioning of the code shown below.
<Diagnosis Functions>
CODE Contents *YMS-Monitor
01 Throttle sensor TPS 1(deg)
02 Atmospheric pressure sensor Atmospheric (kPa)
03 Intake pressure sensor 1 Intake Air (kPa)
05 Intake temperature sensor Air Temp. (°C)
06 Water temperature sensor Water Temp. (°C)
07 Vehicle speed sensor Speed Signal (--)
08 Overturn sensor Lean Angle Signal
(V)
09 Monitor voltage System Voltage (V)
13 Throttle sensor 2 TPS 2 (deg)
14 Accelerator sensor 1 APS 1 (deg)
15 Accelerator sensor 2 APS 2 (deg)
21 Neutral switch Neutral SW
30 Ignition coil #1 —
31 Ignition coil #2 —
32 Ignition coil #3 —
33 Ignition coil #4 —
36 Injector (primary) #1 —
37 Injector (primary) #2 —
38 Injector (primary) #3 —
39 Injector (primary) #4 —
40 Injector (secondary) #1 —
41 Injector (secondary) #2 —
42 Injector (secondary) #3 —
43 Injector (secondary) #4 —
46 Intake funnel —
50 Main relay —
70 Program version —
To Next Page
Loading...
