– 12 –
11. Throttle Body Clamp Assembly (2CO-1351A-70)
This part is used to enhance maintenance performance of the throttle body. Before using it, cut
off the protrusion for positioning bands at the cabjoint.
The part has a collar to prevent over-tightening. In normal cases, the part will not be tightened
till it reaches to the collar. Just manually tighten it.
Make sure to put a new band through a M4 x 0.7 tap before using it.
Parts List
No. PART No. PART NAME Q'TY REMARKS
1 2C0-1351A-70 THROTTLE BODY CLAMP
ASSY.
1
Cut it off
To Next Page
Loading...
