– 52 –
Front Fork Spring Replacement Method
1. Turn the damping adjustor and preload adjustor anticlockwise to set to the weakest
position.
2. After fixing the axle bracket in a vice, turn the fork bolt anticlockwise to lower the outer tube
until the dust seal touches the upper surface of the axle bracket.
3. Insert the spanner
(SPECIAL TOOL) into the notch of the spring seat upper and clamp the
14mm special nut.
4. Use a 14mm box spanner on the preload adjustor to remove the cap bolt assembly.
NOTICE
Do not remove the spanner (SPECIAL TOOL) while doing this.
Axle bracket
Rebound damping adjustor
Preload adjustor
Fork bolt
Spanner
(SPECIAL TOOL)
Preload tube
Spring seat upper
To Next Page
Loading...
