Yamaha ERCX Series User Manual

9-3
9
OPERATING THE ROBOT
9-1 Performing Return-to-Origin
c
CAUTION
When the SERVICE mode function is enabled, the following safety control will function. (See "10-4 SERVICE
mode function".)
• Return-to-origin movement speed is limited to 10mm/s or less (10deg/s for rotary robots) in "SERVICE mode
state" when the robot movement speed limit is enabled.
• If the hold-to-run function is enabled, robot movement stops upon releasing
F1
(yes) in step 3 in
"SERVICE mode state". (You must hold down
F1
(yes) until return-to-origin is complete.)
c
CAUTION
When performing return-to-origin by the stroke-end detection method, do not interrupt the return-to-origin
operation while detecting the origin (while contacting the mechanical limit). Otherwise, the operation will stop
due to a controller overload alarm and the power will have to be turned on again.
c
CAUTION
If return-to-origin operation using the stroke-end detection method must be repeated, wait at least 5 seconds
before repeating it.

Yamaha ERCX Series Specifications

General

Brand	Yamaha
Model	ERCX Series
Category	Controller
Language	English