28
• Inverters with Width of 180
mm
Use a screwdriver to loosen the
screw (section B) on the termi-
nal cover surface. (This screw
can not be removed to prevent
loss.) Then press the right and
left sides in direction 1 and lift
the terminal cover in direction
2.
Mounting the Terminal Cover
Mount the terminal cover by
reversing the order of the above
procedure for removal.
Removing the Digital
Operator
After removing the front cover,
(follow the procedure on page 27)
lift the upper and lower sides (sec-
tion C) of the right side of the Dig-
ital Operator in direction 1.
Mounting the Digital Operator
Mount the Digital Operator by
reversing the order of the above
procedure for removal.
1
1
2
B
C
C
To Next Page
Loading...
