5. Operating the Inverter
47
Function Indicator Description
By pressing on the Digital Operator, each of the function indi-
cators can be selected.
The following flowchart describes each function indicator.
Power ON
Frequency reference setting/monitoring
(Hz)
Sets VS-606V7 operating speed.
Output frequency monitoring (Hz)
Displays frequency that VS-606V7 is
currently outputting.
Setting disabled.
Output current monitoring (A)
Displays current that VS-606V7 is
currently outputting.
Setting disabled.
Multi-function monitoring
Description of the selected monitor is
displayed.
(forward run) (reverse run)
If the VS-606V7 loses
power while in one of
these modes, it will
return to the same
mode once power is
restored.
Monitor No.
U-01: Frequency reference (FREF)
U-02: Output frequency (FOUT)
U-03: Output current (IOUT)
U-04: Output voltage reference (Unit: 1V)
U-05: DC voltage (Unit: 1V)
U-06: Input terminal status
U-07: Output terminal status
U-08: Torque monitor
U-09: Fault history (Last 4 faults)
U-10: Software number
U-11: Output power
U-13: Cumulative operation time
(5.5/7.5 kW only)
U-15: Data reception error
U-16: PID feedback
U-17: PID input
U-18: PID output
U-19: Frequency reference bias
monitor (%) (for software No.
VSP010028 or later)
FWD/REV run selection
Sets the motor rotation direction when the RUN
command is given from the Digital Operator.
Setting can be changed using the or key.
(Refer to page 49 for details.)
To Next Page
Loading...
