38
Wiring the Control Circuits
Only basic insulation is provided for the control circuit terminals.
Additional insulation may be necessary in the end product.
• Control Circuit Terminals
Pass the cable through wiring hole to connect it. Always mount the
cover in its original position.
SW1 can be changed according to sequence input signal (S1 to S7)
polarity.
0 V common: NPN side (Factory setting)
+24 V common: PNP side
Refer to pages 191 and 192 for SW1.
Refer to pages 99 and 110 for SW2.
Insert the wire into the lower part of the terminal block and connect
it tightly with a screwdriver.
Contact Output
0.4 mm max.
2.5 mm max.
Screwdriver Blade WidthWiring the Control Circuit Terminals
To Next Page
Loading...
