48
If n001=5, a Run command can be received even
while changing a constant. If sending a Run command
while changing a constant, such as during a test run,
be sure to observe all safety precautions.
Failure to observe this warning may result in injury.
MNTR Multi-function Monitoring
Selecting the Monitor
This function switches the operation; operation
using the Digital Operator including frequency
setting with potentiometer, operation using the
input terminals, or operation through communications.
Setting can be changed using the or key.
LOCAL/REMOTE Selection
(Local)
(Remote)
Return to
If the VS-606V7 is
stopped after it has
changed to any of
these modes during
operation, it changes
to Program mode
from Drive mode.
Even if the Run
command is turned ON
again, the VS-606V7
does not operate.
However, if n001=5, the
Run command can be
received and the
VS-606V7 will operate.
Constant No./data
Sets and changes data for a constant No.
(Refer to page 51 for details.)
WARNING
Press the key. When is ON, data
can be displayed by selecting the monitor number.
Example: Monitoring the Output Voltage Reference
Select U-04 by
pressing the
or key.
Output voltage reference
is displayed.
or
To Next Page
Loading...
