| Configuration Methods | 49
Parameter Description Configuration Method
HTTPS
Enable or disable the user to access the web
user interface by using the HTTPS.
Default: On.
Web user interface
Endpoint
CTP20/CTP18
HTTPS Port
Specify the HTTPS port for the user to access
the web user interface.
Valid value: Any integer from 1 to 65535. Make
sure that the configured port is available. The
default value is 443.
Web user interface
HTTP & HTTPS
Enable or disable the user to access the web
user interface via the HTTP and HTTPS.
Default: On.
CTP20/CTP18
Endpoint (VP59)
Disabled Disable the user to access the web user
interface via the HTTP and HTTPS.
CTP20/CTP18
Endpoint (VP59)
User and Administrator Account Login
• Changing the Administrator Password
• Enabling the User Type
Changing the Administrator Password
The default administrator name is “admin” and the administrator password is “0000”. Only the user with the
administrator permission can change the password. For security reasons, you should change them as soon
as possible. The administrator password for the system supports ASCII characters 32-126 (0x20-0x7E).
Procedure
1. Do one of the following:
• On your web user interface, go to Security > Security.
• On your VCS, go to More > Settings > Advanced > System Settings > Password Reset.
For VP59, tap > Settings > Advanced > System Settings > Password Reset.
•
On your CTP20/CTP18, tap > Settings > Advanced > System Settings > Password Reset.
2. Configure and save the following settings:
Parameter Description Configuration Method
User Type Select the administrator. Web user interface
Old Password/Current
Password
Enters the old administrator
password.
Default: “0000 ”.
Web user interface
Endpoint
CTP20/CTP18
To Next Page
Loading...
Need help?
General
Weight and Dimensions
