EasyManuals Logo

Yealink CTP20 User Manual

Yealink CTP20
281 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
| Configuring Network Settings | 76
• Configuring Wireless Access Point
• Viewing the Connected Devices
• Adding Connected Devices to the Blocklist
• Removing Devices from the Blocklist
• Disabling the Wireless Access Point
Enabling the Wireless Access Point
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Wireless AP.
• On your VCS: go to More > Settings > Network Setting > Wireless AP > Wireless AP.
For VP59, tap > Settings > Network Setting > Wireless AP > Wireless AP.
•
If CTP20/CTP18 is wired to the VCS devices, on your CTP20/CTP18, tap > Settings > Network
Setting > Host Network > Network > Wireless AP .
2. Enable the Wireless AP.
3. If you already enabled Wi-Fi, select OK to turn it off.
Configuring Wireless Access Point
You can configure the wireless access point for the devices.
Before you begin
Make sure you enable the wireless AP.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Wireless AP > AP Config.
• On your VCS: go to More > Settings > Network Setting > Wireless AP > Configure AP.
For VP59, tap > Settings > Network Setting > Wireless AP > Configure AP.
•
On your CTP20/CTP18, tap > Settings > Network Setting > Host Network > Network >
Wireless AP > Configure AP.
2. Configure and save the following settings:
Parameter Description Configuration Method
AP Name Configure the name of wireless
AP.
Web user interface
Endpoint
CTP20/CTP18
Security Mode
Configure the security mode of
the wireless AP.
• None
• WPA2-PSK
Default: WPA2-PSK.
Web user interface
Endpoint
CTP20/CTP18

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink CTP20 and is the answer not in the manual?

Yealink CTP20 Specifications

General IconGeneral
Aspect ratio16:9
Screen shapeFlat
Display diagonal13.3 \
Touch technologyMulti-touch
Touchscreen typeMulti-user
Touchscreen technologyCapacitive
Number of simultaneous touchpoints10
Product colorBlack
Power consumption (typical)7 W
Ethernet LAN (RJ-45) ports1
OmniTapps Multitouch compatibilityNo
Wi-Fi standardsWi-Fi 4 (802.11n), Wi-Fi 5 (802.11ac)
Harmonized System (HS) code85285210
Weight and Dimensions IconWeight and Dimensions
Depth (without stand)196 mm
Width (without stand)321.5 mm
Height (without stand)118 mm

Related product manuals