Yealink T58A

| Device Network | 12
Web UI Network > Basic > IPv4 Config > Configuration Type(Static IP) > IP Address
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv4 Type(Static IP) > IP Address
Parameter static.network.internet_port.mask
[1]
<MAC>.cfg
Description
It configures the IPv4 subnet mask.
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 &
IPv6), and "static.network.internet_port.type" is set to 2 (Static IP).
Permitted Values Subnet Mask
Default Blank
Web UI Network > Basic > IPv4 Config > Configuration Type(Static IP) > Subnet Mask
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv4 Type(Static IP) > Subnet Mask
Parameter static.network.internet_port.gateway
[1]
<MAC>.cfg
Description
It configures the IPv4 default gateway.
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 &
IPv6), and "static.network.internet_port.type" is set to 2 (Static IP).
Permitted Values IPv4 Address
Default Blank
Web UI Network > Basic > IPv4 Config > Configuration Type(Static IP) > Default
Gateway
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv4 Type(Static IP) > Default Gateway
Parameter static.network.static_dns_enable
[1]
<y0000000000xx>.cfg
Description
It triggers the static DNS feature to on or off.
Note: It works only if “static.network.internet_port.type” is set to 0 (DHCP).
Permitted Values
0-Off, the device will use the IPv4 DNS obtained from DHCP.
1-On, the device will use manually configured static IPv4 DNS.
Default 0
Web UI Network > Basic > IPv4 Config > Static DNS
Parameter static.network.primary_dns
[1]
<MAC>.cfg