Yealink T58A

| Device Network | 11
• IPv6 Configuration
IP Addressing Mode Configuration
The following table lists the parameter you can use to configure IP addressing mode.
Parameter static.network.ip_address_mode
[1]
<MAC>.cfg
Description It configures the IP addressing mode.
Permitted
Values
0-IPv4
1-IPv6
2-IPv4 & IPv6
Default 0
Web UI Network > Basic > Internet Port > Mode(IPv4/IPv6)
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN Port >
IP Mode
[1]
If you change this parameter, the device will reboot to make the change take effect.
IPv4 Configuration
The following table lists the parameters you can use to configure IPv4.
Parameter static.network.internet_port.type
[1]
<MAC>.cfg
Description It configures the Internet port type for IPv4.
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 &
IPv6).
Permitted Values
0-DHCP
2-Static IP
Default 0
Web UI Network > Basic > IPv4 Config > Configuration Type
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv4 Type
Parameter static.network.internet_port.ip
[1]
<MAC>.cfg
Description It configures the IPv4 address.
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 &
IPv6), and "static.network.internet_port.type" is set to 2 (Static IP).
Permitted Values IPv4 Address
Default Blank