Yealink T58A

| Device Network | 22
Phone UI
> Settings > Device Settings > Network (default password: admin) > CDP
> CDP Interval
[1]
If you change this parameter, the device will reboot to make the change take effect.
Manual VLAN Configuration
VLAN is disabled on the devices by default. You can configure VLAN for the Internet port and PC port
manually. Before configuring VLAN on the device, you need to obtain the VLAN ID from your network
administrator.
The PC port is not applicable to CP960, and you can only configure VLAN for the Internet port manually.
The following table lists the parameters you can use to configure VLAN manually.
Parameter static.network.vlan.internet_port_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the VLAN for the Internet port.
Permitted Values
0-Disabled
1-Enabled
Default 0
Web UI Network > Advanced > VLAN > WAN Port > Active
Phone UI
> Settings > Device Settings > Network (default password: admin) > VLAN
> WAN Port
Parameter static.network.vlan.internet_port_vid
[1]
<y0000000000xx>.cfg
Description
It configures the VLAN ID for the Internet port.
Note: It works only if “static.network.vlan.internet_port_enable” is set to 1
(Enabled).
Permitted Values Integer from 1 to 4094
Default 1
Web UI Network > Advanced > VLAN > WAN Port > VID
Phone UI
> Settings > Device Settings > Network (default password: admin) > VLAN
> WAN Port > VID
Parameter static.network.vlan.internet_port_priority
[1]
<y0000000000xx>.cfg
Description
It configures the VLAN priority for the Internet port.
7 is the highest priority, 0 is the lowest priority.
Note: It works only if “static.network.vlan.internet_port_enable” is set to 1
(Enabled).
Permitted Values Integer from 0 to 7
Default 1