Yealink T58A

| Device Network | 27
Parameter static.wifi.X.eap_user_name
[2]
<y0000000000xx>.cfg
Description It configures the EAP authentication username of a specific wireless network.
Note: It works only if "static.wifi.function.enable" and "static.wifi.enable" are set to
1 (Enabled).
Permitted Values String within 64 characters
Default Blank
Parameter static.wifi.X.eap_password
[2]
<y0000000000xx>.cfg
Description It configures the EAP authentication password of a specific wireless network.
Note: It works only if "static.wifi.function.enable" and "static.wifi.enable" are set to
1 (Enabled).
Permitted Values String within 64 characters
Default Blank
[1]
If you change this parameter, the device will reboot to make the change take effect.
[2]
X is the Wi-Fi ID. X=1-5.
Internet Port and PC Port
Yealink Teams devices support two Ethernet ports: Internet port and PC port. You can enable or disable
the PC port on the devices.
The PC port is not applicable to CP960 devices.
• Supported Transmission Methods
• Internet Port and PC Port Configuration
Supported Transmission Methods
Three optional methods of transmission configuration for the device Internet port and PC port:
• Auto Negotiation
• Half-duplex (transmit in 10Mbps or 100Mbps)
• Full-duplex (transmit in 10Mbps, 100Mbps or 1000Mbps (not applicable to CP960))
Auto negotiation is configured for both Internet and PC ports on the device by default.
Internet Port and PC Port Configuration
The following table lists the parameters you can use to configure the Internet port and PC port.
Parameter static.network.pc_port.enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the PC port.
Permitted Values
0-Disabled
1-Auto Negotiation
Default 1
Supported Devices All devices except CP960