Yealink T58A - Page 28

| Device Network | 28
Web UI Network > PC Port > PC Port Active
Phone UI
> Settings > Device Settings > Network(default password: admin) > PC
Port
Parameter static.network.internet_port.speed_duplex
[1]
<y0000000000xx>.cfg
Description It configures the transmission method of the Internet port.
Note: You can set the transmission speed to 1000Mbps/Auto Negotiation to
transmit in 1000Mbps if the phone is connected to the switch which supports
Gigabit Ethernet. We recommend that you do not change this parameter.
Permitted Values
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (not applicable to CP960)
Default 0
Web UI Network > Advanced > Port Link > WAN Port Link
Parameter static.network.pc_port.speed_duplex
[1]
<y0000000000xx>.cfg
Description
It configures the transmission method of the PC port.
Note: You can set the transmission speed to 1000Mbps/Auto Negotiation to
transmit in 1000Mbps if the phone is connected to the switch which supports
Gigabit Ethernet. We recommend that you do not change this parameter.
Permitted Values
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps
Default 0
Supported Devices All devices except CP960
Web UI Network > Advanced > Port Link > PC Port Link
Parameter static.network.vlan.pc_port_mode
[1]
<y0000000000xx>.cfg
Description
It configures the way the phone processes packets for the PC port when VLAN is
enabled on the PC port.
Note: When packets are sent from the Internet port to the PC port, remove the
packet’s tag if it is the same as the configured tag for the PC port, else forward the
packets directly.