Yealink VC400 - Page 219

Configuring System Settings
203
Parameter
Description
Configuration Method
only when the white balance mode
is configured to Manual.
Blue Gain
Configures the blue gain of the
camera.
Valid Values: 0-100
Default: 62
Note: You can set this parameter
only when the white balance mode
is configured to Manual.
Remote Control
Web User Interface
Saturation
Configures the saturation of the
camera.
Valid Values: 0-14
Default:
For VCC18 camera, the default value
is 3.
For VCC20 camera, the default value
is 10.
Remote Control
Web User Interface
Sharpness
Configures the sharpness of the
camera.
Valid Values: 0-14
Default:
For VCC18 camera, the default value
is 1.
For VCC20 camera, the default value
is 8.
Note: The picture will be sharp and
clear, but moderate to heavy motion
at low call rates can cause some
frames to be dropped.
Remote Control
Web User Interface
Brightness
Configures the brightness of the
camera.
Valid Values: 0-100
Default:
For VCC18 camera, the default value
is 8.
For VCC20 camera, the default value
is 1.
Remote Control
Web User Interface