4-1
IM 710105-03E
Operating the DLM2000
4
4.1 Applying Signals to Measure
To help you understand basic oscilloscope operations, this chapter explains how to
use the DLM2000 probe compensation signal and perform procedures from displaying
waveforms to saving data.
Connecting to the Power Supply
Follow the procedure in section 2.3, "Connecting the Power," and turn the DLM2000
power switch on.
Connecting a Probe
Follow the procedure in section 2.4, "Connecting the Probe" to connect the 701938,
701939, or 701946 probe that is supplied with the DLM2000.
On models with the /EX52 or /EX54 option, 701946 passive probes are provided in place
of 701939 passive probes.
On models with the /EX22 or /EX24 option, 701946 passive probes are provided in place
of 701938 passive probes.
Correcting the Probe Phase
Follow the procedure in section 2.5, "Compensating the Probe (Phase Correction)" to
correct the probe phase.
The waveform of the DLM2000 probe compensation signal appears.
Scale value for each channel Time/div value
Note
Because the 701938, 701939, and 701946 passive probes have probe ID pins, the DLM2000
automatically detects the probe attenuation when you connect one of these probes to a
DLM2000 probe terminal.
Chapter 4 Operating the DLM2000
To Next Page
Loading...
