YOKOGAWA FX106 User Manual

2-6 IM 04L20A01-01E
Arrangement of the Measurement Input Terminal Blocks
The measurement input terminal blocks are arranged on the rear panel of the FX100 as
shown in the figure below.
Measurement input terminal blocks
Terminal cover screws
A terminal cover is screwed over the measurement input terminal blocks. A label
showing the arrangement of the terminals is affixed to the cover.
Note
• The installation position of each terminal block is fixed and cannot be changed.
• For a description on the connection of communication interfaces such as the serial or
Ethernet interface, see the “ FX100 Communication Interface User’s Manual ” (IM04L20A01-
17E).
Measurement Input Assignments on the Measurement Input Terminal Block
Measurement inputs are assigned on the FX103, FX106, and FX112 as shown in the
figure below. One measurement input uses three terminals.
231
231564
8971112 10
231564
FX112
FX106
FX103
1 to 12: Measurement input channel numbers
Wiring Procedure
1. Turn OFF the power to the FX100, then remove the terminal cover.
2. Wire the signal wire to the terminal.
Remove the measurement input terminal block to perform the wiring.
Wire gauge: 0.2–2.5 mm
2
(AWG24–AWG17)
Input signal wire
Flathead driver
Removing the terminal block
Hold both sides of the terminal
block, then pull straight out.
Connecting Wires
Insert the input signal wire into the
slit on the underside of the terminal
block, then use a flathead screwdriver
to tighten the front screw.
Recommended length
of wire stripping: 7 mm
2.3 Measurement Input Terminal Wiring

YOKOGAWA FX106 Specifications

General

Brand	YOKOGAWA
Model	FX106
Category	Controller
Language	English