YOKOGAWA GX10 User Manual

2-154
IM 04L51B01-17EN
Operation Event string ### information and detailed information
Unit00,Slot:01,2013/06/05,User01
Module activation ApplyModule —
Module update UpdateModule Unit:uu,Slot:ss,mm•••,ii•••,vv•••
u Unit
s Slot
mm••• Module name
ii••• Serial number
vv••• Version number
Setting changes during recording
Alarm setting change SetAlarm cccc:l:(s,typ,val,hys,l,Otyp,Ono)=(b1,b2,b3,b4,b5,b
6,b7)->(a1,a2,a3,a4,a5,a6,a7)
c Channel
l Level
b1,•••,b7 Before change
a1,•••,a7 After change
The following settings (those that have
been changed among the following seven
settings)
s On/Off [ON, OFF]
typ Type [H,L,R,r,h,l,T,t]
val Alarm value
hys Hysteresis
l Logging [ON, OFF]
Otyp Output type [OFF,DO,SW]
Ono Output number
Example 1:
0001:1:(s,typ,val,hys,l,Otyp,Ono)=(off,TH
,off,-2.000,0.0005,DO,0001)->(off,TL,off,-
2.000,0.0005,SW,001)
Example 2:
0002:2:(val)=(-2.000)->(-1.000)
Alarm delay setting
change
SetAlmDelay cccc:(hour,min,sec)=(b1,b2,b3)->(a1,a2,a3)
cccc Channel
b1,b2,b3 Before change
a1,a2,a3 After change
The following settings (those that have
been changed among the following three
settings)
hour Delay hour
min Delay minute
sec Delay second
Example:
A100:(hour,min,sec)=(00,00,00)->
(01,02,03)
Calibration
correction/set point
change
SetCCModePnt cccc:(mode,num)=(b1,b2)->(a1,a2)
c Channel
b1,b2 Before change
a1,a After change
The following settings (those that have
been changed among the following two
settings)
mode Mode [OFF, Bias, Appro, Corr]
num Number of set points
Example:
0001:(mode,num)=(OFF,3)->(Appro,12)
Calibration correction
value change
SetCCValue cccc:pp:(input,output)=(b1,b2)->(a1,a2)
c Channel
p Set number
b1,b2 Before change
a1,a2 After change
2.10 ASCII Output Format

YOKOGAWA GX10 Specifications

General

Brand	YOKOGAWA
Model	GX10
Category	Voice Recorder
Language	English