EasyManua.ls Logo

YOKOGAWA PH450G

YOKOGAWA PH450G
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
<1. General>
1-2
IM 12B07W01-04EN 1st Edition : Nov 11, 2016-00
Chemicals for Cleaning:
Acid solution (e.g., hydrochloric acid or diluted sulfuric acid), or alkali solution. Organic
solvents are not allowed.
Note: Select appropriate solution for effective cleaning.
Material, Finish, and Color of Main Components:
Control Box (K9729AN)
Material: Aluminum alloy casting
Colors:
Deep sea moss green (Munsell 0.6GY3.1/2.0) and frosty white (Munsell 2.5Y8.4/1.2)
Finish: Baked polyurethane resin coating
Power Supply Unit (for pH/ORP converter only)
Material: Carbon steel (body)
Color: Deep sea moss green (Munsell 0.6GY3.1/2.0 or equivalent)
Finish: Baked polyurethane resin coating
Mounting Rack
Material: Carbon steel
Color: Deep sea moss green (Munsell 0.6GY3.1/2.0)
Finish: Baked polyurethane resin coating
Chemical Solution Tank (20 L, 2 to 10 % diluted hydrochloric acid or diluted sulfuric acid.
Effective capacity; approximately 17 L, approximately 100 ml is used for each cleaning)
Material: Polyethylene resin (for solution tank), and hard PVC resin (for internal tank)
Tubing for Solution, Air, or KCl
Material of tubes: Polyethylene or Fluoropolymer (PTFE)
Mateirial of tting (joint): polypropylene resin or Fluoropolymer (PTFE)
Ambient Temperature: 0 to 45°C (Note ; Freezing protection is required if necessary.)
Power Supply: 100 V AC ±10%, 50/60Hz ±5%
Power Consumption: Approx. 60 VA
Air Supply: 300 to 950 kPa {3 to 9.5 kg/cm
2
}
Max. Air Consumption: Approx. 10 Nl/min.
External Dimensions:
500 (W) x 600 (D) x 1630 mm (H)
Weight: Approx. 50 kg (when the chemical tank is empty)
Output Contact Signal: Cylinder failure
Contact State: Normally open (close on error )
Contact Capacity: 24 V DC, 1 A, 110 V AC 0.3 A (resistance load)
Output:
pH/ORP Converter : 4 to 20 mA DC 2 points (isolated transmission output; maximum load of
600 Ω)
2-Wire Analyzer : 1 to 5 V DC (minimum resistive load of 2 kΩ)
Cable Connection: G 1/2 gland packing is supplied.
Terminal Size: M4
Outside Cable Diameter: Φ9 to Φ12 mm
Piping Connection: Air for Instrumentation: Rc 1/4 female thread
Note 1: Install the KCl reserve tank in an appropriate place at the job site or attached to the stand for the
chemical cleaning unit.

Table of Contents

Related product manuals