York YZ MODEL A - Page 166

JOHNSON CONTROLS
166
FORM 161.01-OM1
ISSUE DATE: 6/8/2018
APPENDIX - MATERIAL SAFETY DATA SHEETS
Page 2 of 5
Safety Data Sheet
Product: Solid State Starter / VSD Coolant
Eye contact
Flush eyes with plenty of water for at least 15 minutes,
lifting lower and upper eyelids occasionally to ensure
complete rinsing. Remove contact lenses if present and
easy to do, then resume rinsing. Get medical attention if
symptoms occur.
Skin contact
Remove contaminated clothing and wash the affected area
with soap and water. Wash contaminated clothing before
reuse.
Ingestion
If swallowed, DO NOT induce vomiting. Rinse mouth and
get emergency medical attention. Do not give anything by
mouth unless instructed to do so by a poison center or
health care provider.
Inhalation
If inhaled, move victim to fresh air. Seek emergency
medical attention if breathing is difficult; perform artificial
respiration if breathing stops.
Note to health care provider
No specific information—treat symptomatically.
Suitable extinguishing media
Use extinguishing media appropriate for the surrounding
fire.
Unsuitable extinguishing media
No information available
Protective equipment and
precautions for firefighters
Stay upwind of the fire. Full protective equipment including
self-contained breathing apparatus should be used. Use
water to cool closed containers. Contain water runoff if
possible.
Specific hazards
Combustion may produce toxic gases.
Hazardous combustion products
Carbon oxides, nitrogen oxides, sulfur oxides,
phosphorous oxides
Personal precautions
Evacuate the area of all non-essential personnel. Do not
touch spilled material without proper protective equipment.
Ventilate the area and mitigate further release if it is safe
to do so. Avoid contact with eyes.
Methods for clean-up
Small spills Contain spill and soak up with an inert absorbent material
and place residues in a properly labeled container for
disposal. Avoid discharge into sewer or surface water.
Large spills
Contain spill using trenches, diking, or absorption with an
inert material (i.e. sand or earth). Reclaim spilled material
into recovery or salvage drums or tank truck for proper
disposal.
Advice on safe handling
Avoid contact with eyes, skin, and clothing. Avoid
breathing vapor or mist. Wash hands thoroughly after
handling.
5. FIRE-FIGHTING MEASURES
6. ACCIDENTAL RELEASE MEASURES
7. HANDLING AND STORAGE
4. FIRST-AID MEASURES