Zebra Z Series User Manual

Troubleshooting
Miscellaneous Printer Problems
128
79695L-002 Rev. A Z Series
®
/RZ™ Series User Guide 6/6/08
Miscellaneous Printer Problems
Table 22 identifies miscellaneous problems with the printer, the possible causes, and the
recommended solutions.
Table 22 • Miscellaneous Printer Problems
Problem Possible Cause Recommended Solution
The LCD displays a
language that I
cannot read
The language parameter was
changed through the control
panel or a firmware command.
1. Press SETUP/EXIT to enter configuration
mode.
2. Press
MINUS (-).
The printer displays the
LANGUAGE
parameter in the current language. Even if
you cannot recognize the characters
displayed, you can still scroll to another
language.
3. Press
SELECT to select the parameter.
4. Press
PLUS (+) or MINUS (-) to scroll
through the choices until you find a language
that you can read.
5. Press
SETUP/EXIT.
The LCD displays
SAVE CHANGES in the
original language.
6. Press
SETUP/EXIT again to exit
configuration mode and save the changes
(if the language does not change, you may
need to scroll to a different save option by
pressing
PLUS (+) or MINUS (-) in the
previous step).
7. Repeat this process, if necessary, until you
reach the desired language.
The LCD is missing
characters or parts of
characters
The LCD may need replacing. Call a service technician.

Zebra Z Series Specifications

General

Print Method	Thermal Transfer or Direct Thermal
Max Print Width	4.09 in./104 mm (depending on model)
Max Print Length	39 in./991 mm (with 203 dpi)
Connectivity	USB, Serial (depending on model)
Supported Media Types	Wristbands
Media Width	1.0 inch (25.4 mm)
Operating Temperature	40°F to 104°F (5°C to 40°C)
Storage Temperature	-40° F/-40° C to 140° F/60° C
Resolution	203 dpi or 300 dpi (depending on model)