Start-Up
Carl Zeiss Attaching condensers Axiostar plus
2-14 B 40-815 e 12/01
1 Condenser carrier
2 Spring pin
3 Centering screws
4 Groove
5 Orientation screw
6 Aperture diaphragm lever
7 Condenser
Fig. 2-12 Attaching Abbe condenser 0.9/1.25
1 Condenser
2 Guiding slot
3 Slider for phase contrast or darkfield
4 Orientation screw
Fig. 2-13 Inserting slider for phase contrast
or darkfield
2.8 Attaching condensers
2.8.1 Attaching Abbe condenser
0.9/1.25
• Unscrew both centering screws (2-12/3) on
the condenser carrier (2-12/1) until the
Abbe condenser 0.9/1.25 (2-12/7) can be
easily inserted into the condenser carrier.
• Insert the condenser into the condenser
carrier in such a way that
1. the dovetail of the condenser is pressed
against the spring pin (2-12/2) in the
condenser carrier and
2. the orientation screw (2-12/5) on the
underside of the condenser enters the
groove (2-12/4) on the condenser
carrier.
• Tighten both centering screws (2-12/3) on
the condenser carrier (2-12/1) until they
engage in the dovetail and keep the
condenser (2-12/7) in position.
2.8.2 Inserting slider for phase
contrast or darkfield
• Insert the slider (2-13/3) until it engages in
the opening in the condenser (2-13/1); the
orientation screw (2-13/4) must face
upwards and engage in the guiding slot
(2-13/2).
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page