Zeiss Axiostar plus - Attaching MC 80 DX Microscope Camera (Film Cassette 35 MM)

Operation
Carl Zeiss Photomicrography equipment Axiostar plus
3-20 B 40-81 e 12/01
1 35 mm Mot DX film cassette
2 MC 80
DX basic body
3 Clamping ring
4P 2.5× projection lens
5 Adapter 60 for microscope cameras
6 Phototube
7 Hexagonal screws
8 Control
9 Dust protection cap
Fig. 3-14 Attaching MC 80
DX microscope
camera
3.9.2 Attaching MC 80 DX microscope
camera (film cassette 35 mm)
• Loosen hexagonal screws (3-14/7) and
remove dust protection cap (3-14/9) from
the phototube.
• Insert adapter 60 for microscope camera
(3-14/5) (456006-0000-000) into phototube
(3-14/6) and fix it using three hexagonal
screws (3-14/7).
• Insert P 2.5× projection lens (3-14/4) into
adapter 60 for microscope cameras
(3-14/5).
• Attach MC 80
DX basic body (3-14/2) onto
adapter 60 for microscope cameras until
stop, align it and fix it by turning clamping
ring (3-14/3) anti-clockwise.
• Attach 35 mm Mot DX film cassette
(3-14/1) to the basic body in such a way
that the contact pins firmly engage in the
relevant sockets.
• For microphotography, turn control knob
(3-14/8) counterclockwise until stop. When
using the phototube 30°
ICS, pull out the
lever for light path switching completely
(100 % light to camera port).
When artificial light color reversal film is used,
the CB 3 conversion filter provides the correct
color temperature of 3200 K. The filter must be
placed on the dust cover of the luminous-field
(3-2/2), as mentioned in chapter 3.1.
For daylight color reversal film, the CB 12
conversion filter must also be used. The filter
must be placed on the dust cover of the
luminous-field diaphragm (3-2/2), as described
in chapter 3.1.
☞
For detailed information on the MC 80 DX,
please see manual B 40-036-d, “Microscope
Camera MC 80
DX.”
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com