EasyManuals Logo

Zendure Hub 2000 User Manual

Zendure Hub 2000
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
3
3.1 Usage
3. SAFETY INSTRUCTION
Hub 2000 controller doesn’t include a battery pack, and the battery needs to be
purchased separately. For more information about battery AB1000 or AB2000
or SuperBase V or Satellite Battery, please check the user manual of AB1000 or
AB2000 or SuperBase V or Satellite Battery.
1. Please check whether SolarFlow is damaged, cracked, liquid leakage,
heat or other abnormalities or cables are damaged before operating.
If any, please stop using the product immediately and contact our
customer service.
2. Keep a distance of 50mm between Hub 2000 and other objects.
3. During the operation of the solar energy system, avoid direct sunlight
to prevent the SolarFlow system from overheating. Do not place the
SolarFlow near any heat source.
4. Do not use around strong static electricity or magnetic elds.
5. It is prohibited to place the equipment in an environment with
ammable, explosive gas, or smoke. Since SolarFlow relies on the shell
to dissipate heat, over-temperature of the shell will lead to damage.
6. Do not attempt to replace the internal components of the equipment
by any unauthorized personnel.
7. Please install the product according to our user manual to avoid
damage to the product or injury to other people.
8. Ensure before nishing installation, the solar cable, the Microinverter
cable to home grid are disconnected.
9. Ensure that Hub 2000 and Microinverter are installed rmly to avoid
accidents and product damage caused by dropping.
10. SolarFlow has a protection level of IP65, so the product cannot be
immersed in liquids. If the product accidentally falls into water during
use, please place it in a safe and open area and keep it away until it is
completely dry. The dried product should not be used again and should
be properly disposed of according to the disposal guidelines in this
manual.
11. Please ensure proper ventilation while in use, inadequate ventilation
may cause permanent damage to the equipment.
12. Do not place anything on the top of SolarFlow, please install it where
people cannot touch it.
EN
Output to SuperBase V or Satellite Battery
Max Input Power 1800W
Max Input Current 37.5A
Rate Voltage 45-58.4V

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zendure Hub 2000 and is the answer not in the manual?

Zendure Hub 2000 Specifications

General IconGeneral
BrandZendure
ModelHub 2000
CategorySwitch
LanguageEnglish