Global BPM
The Global BPM encoder is used to adjust the Global BPM (beats per minute) speed from 1 to 600 BPM. The central
button acts as a Tap Tempo, and the encoder can be dialled to speed up / slow down the current Tap Tempo. Any
chase can be set to use the “Global BPM” rather than its own individual BPM.
See Chase Settings for more information.
Programmer Time
When enabled, Programmer Time will apply a fade to live commands in the programmer. This fade time can then be
applied to anything in the programmer, ideal for “busking” shows. The encoder will allow you to set any value between
0.0 (snap) and 11:30.0. This time is displayed just above the encoder on the touch screen. To enable the Programmer
Time function, press the middle button of the encoder. Now, activating palettes, changing intensities via syntax,
clearing the programmer, releasing playbacks, Highlight & Rem Dim etc will all take the time set on the encoder, rather
than happening instantly.
Programmer Time is an ideal tool to use for busking. Take a look at
the video for a quick explanation of the term busking in the world of
lighting.
Speed Override, Global BPM, and Programmer Time, can be configured to be controlled by playback faders, as
well as the encoders. For more information click here.
Zero 88 - ZerOS - Page 161 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
