806834 v1.02 07.21 G5 Online install instructions and user guide
65
SAFETY
INSTALLATION
TROUBLE
SHOOTING
COMMISSION
USER GUIDE
TAP SAFETY
LCD SCREEN
CONTACT
INSTALLATION
GUIDE
• Follow filter flush procedure , page 86.
Section 5 Commissioning
5.4 Filter flush
12:12 PMTANK FLUSH
Follow the prompts to flush fresh water through the
tank/s 3 times as shown by the cycle counter/s.
The tank/s will fill automatically but when
prompted use the tap to dispense and empty.
Dispense water from the hot tank using the taps
safety feature.
5.5 Tank flush (does not apply to chilled sparkling models)
• Upon first use, the HydroTap water tanks must be flushed
with fresh water.
• Follow the instructions to flush the tanks. Dispense water
from the tap as instructed.
• Note Once the tank is full it is necessary to empty each
tank until the HydroTap starts to fill again. If the tank is not
emptied completely the tank flush will not be complete and
will time out. This requires the commissioning process to be
started again.
5.3 CO2 purge (sparkling models only)
• See page 91.
• Touch the arrow to continue , when ready to start using the
HydroTap.
5.6 Boiling calibration (boiling models only)
• Press the green button and the system will start the boiling
calibration procedure. This will take approx. 5 to 6 minutes.
To Next Page
Loading...
