ProFace X Series User Manual
Page | 67 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Delete a door-unlocking combination
Set all the group numbers as 0 if you want to delete door-unlocking combinations.
Anti-Passback Setup
It is possible that users may be followed by some persons to enter the door without verification, resulting
in security problem. So, to avoid this situation, Anti-Passback option is developed. Once it is enabled, the
check-in record must match with check- out record so as to open the door.
This function requires two devices to work together: one is installed inside the door (master device), the
other one is installed outside the door (slave device). The two devices communicate via Wiegand signal.
The Wiegand format and Output type (User ID / Badge Number) adopted by the master device and slave
device must be consistent.
Click Anti-passback Setup on the Access Control interface.
To Next Page
Loading...
Need help?
General
