16
2. Click the direction key“ ”to select“ ”and then press“ ”key to enter Machine
interface.
3. Click“ ”direction key，select the standby item on the setting interface；
4. Set the time to automatically go to standby mode；
5. After setting, click“ ”direction key to move the cursor to the upper right corner“ ”，
click“ ”to close the current interface and go back to the system application interface，
continue to repeat this action will return to the waveform acquisition interface. Or just click
the“ ”on the panel to go back to system application interface，continue to repeat this
action will return to the waveform acquisition interface。
Turn off the display in standby mode, can reduces power consumption and extends display life.
2.2.3 Demo Mode
In this mode, the ECG can demonstrate some features of the machine without connecting the
patient cable and accessories. Click the " " to enter system application interface. Click
“ ”direction key to select“ ”, click“ ”to enter analysis setting interface→click
direction key“ ”or“ ” to select “ ”→ click direction key “▲”or“▼”to select【Demo
mode】,click ” to confirm, then click direction key “▲”or“▼”to select turn this mode on or
off. Finally click “ ” to confirm. After setting is done, click direction key“▲”or“▼”to move the
cursor to the upper right corner“ ”,click“ ” to close the current interface and return to the
system application interface, continue to repeat this action will close the system application
interface to enter demo mode. Or just click the “ ” on the panel to complete the
operation.
To Next Page
Loading...