29
D. Unfold the first page of the folding paper;
E. Close the printer door.
The black-marked end of recording paper should stay close to the
black-marked detecting end of the recorder.
The grid side of recording paper should face up to the printer head.
The end page of recording paper is marked red. Make sure it is placed on the
bottom.
Recording paper should be placed above the plastic pull tab.
Place the recording paper naturally while installing. Keep the lower edge of
recording paper close to that of the printer door. Don’t center it deliberately.
When close the printer door, parallel the vertical grid line of recording paper to
the tearing margin as possible in case of the paper jam caused by huge
placement deviation while printing.
Please use the paper recommended by the manufacturer.
3.4 Connecting the Patient Cable
Correctly connect the ECG cable to the lead connector at the right side of the machine.
Tighten the screws on patient cable connector and attach the cable to the ECG machine.
The other end of the cable shall be connected to the patient via electrodes. For more details,
please refer to Chapter 5.
To Next Page
Loading...