Zoom G2.1NU - Using the Looper; Record and Overdub Phrases

14
UsingtheLooper
ZOOM G2Nu/G2.1Nu
■ Ifanotemarkwaschosen
Recordingcontinuesforthesettimeandthenloop
playbackstarts(and"PLAY"appearsonthedisplay).
■ If"Manual"waschosen
Whenthe[▲]footswitchispressedagain,orthe
maximumtime(about5seconds)isreached,loop
playbackstarts(and"PLAY"appearsonthedisplay).
4.Recordaphraseandplayitback
Press the [▲] foot switch, and play the phrase that you want to record.
"REC" appears on the display and recording starts.
Dependingontherecordingmethodchoseninstep2,recordingoccursasfollows.
"REC" appears on the display and overdubbing starts.
Whentheendoftherecordedphraseisreached,playbackreturnstotheloopbeginningandoverdubbingcontinues.
Loop playback
Playback
Recording
[▲] foot switch
[▲]
foot
switch
Set time
Loop playback
Playback
Recording
[▲] foot switch
5.Overdubaphrase
During loop playback, press the [▲] foot switch.
HINT
Whenusingthelooper,theunitcanalsoplayarhythm(→P16).However,the
parameter knobs only control the looper.