Zoom G2.1NU - Page 15

15
UsingtheLooper
ZOOM G2Nu/G2.1Nu
Over-
dubbing
Loop
playback
Loop
playback
Playback
Recording
[▲] foot
switch
[▲] foot
switch
HINT
Tostoploopplayback,pressthe[▼]footswitch("STOP"appearson
thedisplay).Tostartloopplaybackagain,pressthe[▲]footswitch.
6.Adjustthephrasevolume
7.Erasethephrase
8.Returntoplaymode
Turn Parameter knob 3.
Thesettingrangeis0–100.
Press the [▼] foot switch until "CLEAR" appears on the display
to erase the recorded phrase.
PRESS both [▼]/[▲] foot switches.
NOTE
PleasenotethatifyouturnParameterknob1or2whenaphrasehas
already been recorded, that phrase will be erased.
To end overdubbing, press the [▲] foot switch again.
"PLAY"appearsonthedisplay.
PHRASEvolume