: Patch editing
You can create patches that combine effects together, change effect types in patches, or change
processing however you like by adjusting the depth of effects using their parameters.
Press [EXIT] to return.
3
Press [EXIT] to finish.
3
Press [EXIT] to finish.
2
HINT
• Some patches say “Empty,” because no modules
in the patch have been set yet.
• When you want to edit the ZNR module, go to the
page with “TOTAL” in the first row.
• You can individually edit the modules arranged in
the L/R Channels of the DUAL MIC ALGORITHM.
Your selection is the left channel when the first
row displays “L” and the right channel when the
first row displays “R.”
• In the 8 x COMP EQ ALGORITHM, each channel
has its own HPF, COMPRESSOR and EQ
modules and you can turn each effect module on/
off on each channel independently. You can check
the current channel by looking at the number in
the first row of the display.
NOTE
• You cannot edit an algorithm itself, including
the combination and arrangement of the effect
modules.
• If you turn “off” an effect module, all the settings
after the effect module, such as the type and
parameters will also be turned off.
• When you are using 8 x COMP EQ, you cannot
turn an effect on or off for all channels at once.
But if you press [ENTER] when an effect setting
value is displayed for the desired channel, you
can switch it off for that channel.
• You cannot turn off the “TOTAL” modules.
• There is no ZNR module in the 8 x COMP EQ
algorithm.
• If you change to another patch without saving a
patch that shows the ‘E’ mark, your edits will be
lost completely. Please refer to the next page for
patch saving.
Adjust the effect parameters
Change INSERT EFFECT name
Change SEND RETURN EFFECT name
Set the effect module
Edit effect modules
5
Turn the effect types on/off.
Effect module off
Compressor
Off
Type (effect module) ON
COMP/LIMITER E
Compressor
E: Edit mark
Effect type Shown after you edit or change
Press [ENTER] to switch.
2
Set the value.
Ensemble E
Depth=2
Change
value
1
Select a parameter.
Ensemble E
Depth=2
Change
parameters
Effect
Effect on/off switch.
If “INSERT EFFECT Off” is
displayed, press [ENTER].
1
Edit the patch level
(final patch sound volume)
7
Set the patch level.
Change
value
TOTAL
Patch Level=25
Change module
6
Select the effect module.
Effect type
COMP/LIMITER E
Compressor
MOD/DELAY E
Chorus
Change module
8
Press [EXIT] to return.
Select .
4
No.15:Standard
>EDIT E
Change
item
Press [ENTER].
>EDIT
Insert effect
Send return effect
or
Press [INSERT
EFFECT] or
[SEND RETURN
EFFECT].
CLEAN <IN1>
No.15:Standard E
2
Select the algorithm/patch.
Change
patch
Change
algorithm
3
Press [ ].
1
TOTAL
Patch Leve1=25
Select .
TOTAL
Change module
Press[ ].
2
Press [ ] until you see
PATCH NAME.
Change
value
Patch Name
S tandard
Blinks
Change name
Press[ ].
1
Press [ ] until you see
PATCH NAME.
Patch Name
S tandard
Blinks
Change name
To Next Page
Loading...
