Zoom R16 - Patch Import; Importing Individual Effect Patches; Importing All Patches from Another Project

Insert effect/send return effect>Patch sel>Save Insert effect/send return effect>Patch sel>Import
Import all patches.
IMPORT>ALL
Import one patch.
IMPORT>PATCH
53
54
Once you have edited a patch, use “SAVE” to save it. You can save a patch at any place within
the same algorithm.
HINT
• You can save your edited patch at any place within
the same algorithm.
• You can make a patch copy by saving an existing
patch to a different area.
NOTE
• These procedures are the same for both insert
and send return effects.
• If you switch to another patch without saving
an edited patch, you will lose all the edits.
Remember to always save your edited patches.
• The import source and the import destination are
different projects when using PATCH IMPORT.
Press [ENTER].
5
Select the place to save.
Change place to
save
Save to
NO.29:Empty
Save location number: patch name
Press [ENTER].
6
Execute [SAVE] action.
NO.29:Empty
Save?
5
Change menu. Select import method.
Change menu>ALL: import all patches from the
target project
Change menu>PATCH: select one patch and
import it from the target project
PATCH IMPORT
>ALL
Change
menu/item
No.001 : PRJ001
All Patch Import?
Press [ENTER].
Confirm the project to import from
and press [IMPORT].
3
NO.01:Ensemble
Import?
Press [ENTER].
Import the patch.
5
Effect
: Patch save
Change
patch
Change
algorithm
2
Select the algorithm/patch.
CLEAN <IN1>
No.15:Standard E
Patch has been edited
3
Press [ ].
Effect
: Patch import
Import one or all patches that have been created in another project to use in the current project.
2
Select the project to import from.
PATCH IMPORT
No.001:PRJ001
Source project number and name
Change
project
Press [ENTER].
Import
No.00:Standard
Source patch number
Change
patch
Select the patch to import.
3
Press [ENTER].
Import to
No.00:Standard
Destination patch number
(save location)
Change
place to save
Select the patch to import.
4
Press [ENTER].
2
Select the project to import from.
ALL PATCH IMPORT
No.001:PRJ001
Source project number and name
Change
project
Press [ENTER].
Select .
1
PATCH IMPORT
>ALL
Change item
Press [ENTER].
>ALL
Select .
4
Press [ENTER].
No.00:Standard
>IMPORT
Change
menu
>IMPORT
Select .
1
PATCH IMPORT
>PATCH
Change item
Press [ENTER].
>PATCH
Select .
4
No.00:Standard
>SAVE
Press [ENTER].
Change
menu
>SAVE
Insert effect
Send return effect
Insert effect
Send return effect
Effect ON/OFF switch
press [ENTER].
When “INSERT EFFECT Off” is displayed,
1
or
Press [INSERT
EFFECT] or
[SEND RETURN
EFFECT].
See steps 1~3 on the previous
page.