5 Configure the Internet
Note
What to do when 3G/4G device is not ready?
1. Check whether the dongle is plugged in.
2. If the device is already plugged in, please check whether the USB is contacted well.
3. If the device is still unrecognized, maybe it has been damaged. Please replace the
device.
Steps
1. Insert 3G/4G device.
2. On the main page of the ZXHN H3601, select Internet > WAN > 3G/4G > Mobile
Network to the Mobile Network page. The signal strength can verify the network
card is plugged, see Figure 5-6.
Figure 5-6 Mobile Network
3. Click Refresh to refresh the information.
4. On the main page of the ZXHN H3601, select Internet > WAN > 3G/4G to the 3G/4G
Connection page.
Table 5-3 lists the New Item parameter. After the setup is complete, you can see the
page , see Figure 5-7.
Table 5-3 New 3G/4G Connection parameters
Parameter Description
Connection Name Name the 3G/4G connection. For example "3G/4G”.
PDP Type There are two PDP types:
IP
PPP
APN Set the communication standard of the access network to
be used.
SJ-20200429083356-004 | 2020-07-23(R1.0) 5-7
To Next Page
Loading...
