ZXHN H3601 Maintenance Management Guide
Parameter Description
Click Off to disable the function.
Name Name of the Service Control item.
The name must be specified.
Target Specify to discard or permit the data packages.
Ingress Specify the data stream inbound direction, and this parameter must
be specified.
If the Ingress is WAN_All, all the WAN connection can access
ZXHN H3601.
If the Ingress is LAN, the LAN side can access ZXHN H3601.
Prefix IPv6 address prefix.
Service Type Type Specify the service that is permitted or denied to access.
3. Click Apply button to apply the changes.
Remote Service Port Control-IPv4
1. Click Remote Service Port Control - IPv4 to open Remote Service Port Control -
IPv4 page, see Figure 5-18.
Figure 5-18 Remote Service Port Control - IPv4 Page
2. Configure the remote service port control - IPv4 parameters.
Table 5-12 lists the remote service port control - IPv4 parameters.
Table 5-12 Parameter Descriptions for the Remote Service Port Control - IPv4
Parameter Description
HTTP The remote service port control of HTTP.
FTP The remote service port control of FTP.
TELNET The remote service port control of TELNET.
HTTPS The remote service port control of HTTPS.
5-18 SJ-20200429083356-004 | 2020-07-23(R1.0)
To Next Page
Loading...
