Zte ZXHN H3601 - Page 59

6 Configure the Local Network
Parameter Description
Prefix Delegate Type Option:
 AutoSense: One prefix selected automatically from all the
available prefixes will be delegated.
 Manual: One or more prefixes selected manually from all the
static prefixes configured before will be delegated.
 Disabled: No prefix will be delegated.
3. Click Apply button to apply the changes.
Configure the RA service.
1. Click RA Service to open the RA Service page, see Figure 6-15.
Figure 6-15 RA Service Page
2. Configure the RA service parameters. Table 6-11 describes the RA service
parameters.
Table 6-11 Description of the RA Service Parameters
Parameter Description
RA Service Select On to enable the RA service.
Select Off to disable the RA service.
Specify MTU If On button is selected, enter the MTU value.
Preference By default, the preference is Middle.
MTU Define the maximum transfer unit.
Minimum Retry Interval/
Maximum Retry Interval
The minimum/maximum time allowed between two unsolicited
multicast router advertisements sent from the interface.
M, O M: managed address configuration.
SJ-20200429083356-004 | 2020-07-23(R1.0) 6-13