7 Configure the Management and Diagnosis
STUN Configuration
1. Click STUN Configuration to the STUN configuration page, see Figure 7-11.
Figure 7-11 STUN Configuration
2. Configure the STUN configuration parameters. Table 7-5 lists the STUN
configuration parameters.
Table 7-5 Parameter Descriptions for the STUN Configuration
Parameter Description
Enable After the STUN function is enabled, clients after NAT (or
multiple NAT) can find their public network addresses, and
determine the type of NAT and the Internet port bound to
the local port. These information is used to create UDP
communication between two hosts after the NAT router.
Server Address The address of the server
3. Click Apply button to apply the changes.
Certificate Management
1. Click Certificate Management to the certificate management page, see Figure 7-12.
Figure 7-12 Certificate Management
2. Select a ACS CA certificate chain.
3. Click Browse to select an ACS CA certificate, and click Import Certificate.
SJ-20200429083356-004 | 2020-07-23(R1.0) 7-9
To Next Page
Loading...
