Zte ZXR10 5900E Series - VLAN Configuration Example

Chapter2RIPConguration
3.Whentheswitchwhichsendsrequestreceivestheresponsemessage,itwillprocess
therouteupdatemessageinformationcontaininginresponsemessage.
lForannewrouteentry,therouteraddsthenewrouteandIPaddressofthead-
vertisedroutertoitsroutingtable.
lForanexistentRIProute,therouterreplacestheoriginalrouteentryonlywhen
thenewroutehaslesshopcount.
2.2ConguringRIP
RIPcongurationincludesthefollowingcontents,basicconguration,enhanced
congurationandversionconguration.
ConguringRIPBasicFunctions
TocongureRIPbasicfunctiononZXR105900E,performthefollowingsteps.
1.EnablingRIP
StepCommandFunction
1ZXR10(config)#routerripThisenablesRIProuting
processandentersRIP
congurationmode.
2ZXR10(config-rip)#network<ip-address><
wildcard-mask>
Thisdesignatesanetwork
segmentforRIProuting.
IncasethattheIPaddress
oftheinterfacebelongs
tothedesignatednetwork
segment,RIPisenabledon
thisinterface.
2.AdjustingRIPtimer
StepCommandFunction
1ZXR10(config)#routerripThisenablesRIPprocess
andentersRIPconguration
mode.
2ZXR10(config-rip)#timersbasic<update><invalid><hol
ddown><flush>
ThisadjustsRIPnetwork
timer.
3ZXR10(config-rip)#output-delay<packets><delay>Thissetsthedelaytimefor
sendingRIPupdatepackets.
Descriptionsoftheparametersusedbystep2areshownbelow.
2-3
SJ-20150114102049-003|2015-01-15(R1.0)ZTEProprietaryandCondential