Zte ZXR10 5900E Series - MAC Address Table Configuration Example

ZXR105900ESeriesCongurationGuide(IPv4Routing)
ModifytheOSPFparametersoninterfacesthatruntheOSPFprotocol,seeFigure3-3.
RouterIDsarelistedbelow:
DeviceRouterID
S11.1.1.2
S21.1.1.3
Figure3-3OSPFInterfaceAttributeConguration
EnabletheOSPFprotocolonS1andS2,andadvertisethenetworksegment.
RunthefollowingcommandsonS1:
S1(config)#interfaceloopback1
S1(config-if-loopback1)#ipadderss1.1.1.2255.255.255.255
S1(config-if-loopback1)#exit
S1(config)#interfacevlan10
S1(config-if-vlan10)#ipaddress30.0.0.1255.255.255.252
S1(config-if-vlan10)#exit
S1(config)#routerospf10
S1(config-ospf-10)#network30.0.0.00.0.0.3area0
S1(config-ospf-10)#router-id1.1.1.2
S1(config-ospf-10)#exit
RunthefollowingcommandsonS2:
S2(config)#interfaceloopback1
S2(config-if-loopback1)#ipadderss1.1.1.3255.255.255.255
S2(config-if-loopback1)#exit
S2(config)#interfacevlan10
S2(config-if-vlan10)#ipaddress30.0.0.2255.255.255.252
S2(config-if-vlan10)#exit
S2(config)#routerospf10
S2(config-ospf-10)#router-id1.1.1.3
S2(config-ospf-10)#network30.0.0.00.0.0.3area0
S2(config-ospf-10)#exit
ModifytheOSPFattributes.
RunthefollowingcommandsonS1:
3-12
SJ-20150114102049-003|2015-01-15(R1.0)ZTEProprietaryandCondential