Zte ZXR10 5900E Series - Page 23

Chapter2RIPConguration
StepCommandFunction
4ZXR10(config-if)#ippoison-reverseThisenablespoison-reverse
mechanism.
Bydefault,itisenabled.Use
notodisablepoison-reverse
mechanism.
Itissuggestedthatusersdonotchangethedefaultstateofsplithorizonunlessto
ensuretoadvertiseroutecorrectly.Ifthesplithorizonisdisabledonserialport(and
theportconnectstopacketswitchingnetwork),thenthoseofalltherelatedrouters
andaccessservershavetobedisabled.
4.Conguringrouteredistribution
ToredistributeroutesfromaroutingdomaintoRIProutingdomain,performthe
followingsteps.
StepCommandFunction
1ZXR10(config)#routerripThisentersRIPconguration
mode.
2ZXR10(config-rip)#redistribute<protocol>[process-i
d][metric<metric-value>][route-map<name>]
Thisredistributesroutesof
otherroutingprotocolstoRIP .
Descriptionsoftheparametersusedbystep2areshownbelow.
ParameterDescription
<protocol>Sourceroutingprotocolofrouteredistribution,which
canbethefollowingkeyword:ospf-ext,ospf-int,static,
bgp-ext,bgp-int,connected,isis-1,isis-2,andisis-1-2
<protocol>Thesourceprotocolredistributed.Itcanbeospf-ext,
ospf-int,static,bgp-ext,bgp-int,connected,isis-1,isis-2
orisis-1-2.
metric<metric-value>Speciestheroutemetrictointroducetheroute.Ifitisnot
specied,thedefault-metricisused.Itsrangeis1-16.
route-map<map-tag>Thenameoftheroutemapforredistribution,1-31
characters.
ConguringRIPVersion
ZXR105900EsupportsRIPv1andRIPv2,anditusesRIPv2bydefault.
TospecifyRIPversionforrouterreceivingorsendingpackets,usethefollowing
commands.
2-7
SJ-20150114102049-003|2015-01-15(R1.0)ZTEProprietaryandCondential