Zte ZXR10 5900E Series - Configuring UDLD

ZXR105900ESeriesCongurationGuide(IPv4Routing)
StepCommandFunction
1ZXR10(config)#routerisis<process-id>[vrf<vrf-name>]EnablestheIS-ISprotocol.
2ZXR10(config-isis-0)#area<area-address>ConguresanIS-ISareain
IS-ISroutingmodeandsetthe
routertothisarea.
Theareaaddressisahex
characterstringwith1-13
bytes.
3ZXR10(config-isis-0)#system-id<system-id>[range
<range-number>]
SetsasystemIDfortheIS-IS
protocol.AnsystemIDisused
toidentifyarouterinanarea.
Itisahexcharacterstringwith
6bytes.Usually,itisaMAC
addressofaninterfaceonthe
router.
Bydefault,arouterrunningthe
IS-ISprotocolisidentiedtobe
LEVEL-1-2.
ZXR10(config-isis-0)#interface<interface-name>Entersinterfaceconguration
mode.
4
ZXR10(config-isis-0-if-vlan100)#iprouterisisSpeciesaninterfacetorun
theIS-ISprotocol.
ConguringIS-ISGlobalParameters
ForanetworkonwhichallZXR10seriesroutersorswitchesrun,usethedefault
parametersinIS-ISconguration.T oconnecttodevicesofothermanufactories,the
relatedinterfaceparametersandtimersshouldbeadjustedtoacquirehigherrunning
efciency.
TocongureIS-ISglobalparametersontheZXR105900E,performthefollowingsteps:
StepCommandFunction
1ZXR10(config)#routerisis<process-id>[vrf<vrf-name>]EntersIS-ISrouteconguration
mode.
2ZXR10(config-isis-0)#is-type{level-1|level-1-2|
level-2-only}
Setsanoperationmodeforthe
router.
Theoperationmodes
includelevel-1,level-1-2,
andlevel-2-only.
3ZXR10(config-isis-0)#metric-style<narrow|wide>Conguresthemetricstyle.
Default:narrow.
4-12
SJ-20150114102049-003|2015-01-15(R1.0)ZTEProprietaryandCondential