Chapter 16 SSL VPN
ZyWALL (ZLD) CLI Reference Guide
108
The following sections list the SSL VPN commands.
16.2.1 SSL VPN Commands
This table lists the commands for SSL VPN. You must use the configure terminal
command to enter the configuration mode before you can use these commands.
application_object The name of an SSL application object. You may use up to 31 characters
(“0-9”, “a-z”, “A-Z”, “-” and “_”). No spaces are allowed.
user_name The name of a user (group). You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number.
This value is case-sensitive.
Table 57 Input Values for SSL VPN Commands (continued)
LABEL DESCRIPTION
Table 58 SSL VPN Commands
COMMAND DESCRIPTION
show sslvpn policy [profile_name] Displays the settings of the specified SSL VPN access policy.
show network-extension local-ip Displays the IP address that the ZyWALL uses in setting up the SSL
VPN.
show sslvpn monitor Displays a list of the users who are currently logged into the VPN
SSL client portal.
sslvpn network-extension local-ip
ip
Sets the IP address that the ZyWALL uses in setting up the SSL
VPN.
sslvpn policy {profile_name |
profile_name append |
profile_name insert <1..16>}
Enters the SSL VPN sub-command mode to add or edit an SSL VPN
access policy.
[no] activate Turns the SSL VPN access policy on or off.
[no] application
application_object
Adds the SSL application object to the SSL VPN access policy.
[no] description description Adds information about the SSL VPN access policy. Use up to 60
characters (“0-9”, “a-z”, “A-Z”, “-” and “_”).
[no] network-extension
{activate | ip-pool
address_object | 1st-dns
{address_object | ip } | 2nd-
dns {address_object | ip } |
1st-wins {address_object | ip
} | 2nd-wins {address_object
| ip } | network
address_object}
Use this to configure for a VPN tunnel between the authenticated
users and the internal network. This allows the users to access the
resources on the network as if they were on the same local network.
ip-pool: specify the name of the pool of IP addresses to assign to
the user computers for the VPN connection.
Specify the names of the DNS or WINS servers to assign to the
remote users. This allows them to access devices on the local
network using domain names instead of IP addresses.
network: specify a network users can access.
[no] user user_name Specifies the user or user group that can use the SSL VPN access
policy.
sslvpn policy move <1..16> to
<1..16>
Moves the specified SSL VPN access policy to the number that you
specified.
sslvpn no connection username
user_name
Terminates the user’s SSL VPN connection and deletes
corresponding session information from the ZyWALL.
no sslvpn policy profile_name Deletes the specified SSL VPN access policy.
sslvpn policy rename profile_name
profile_name
Renames the specified SSL VPN access policy.
To Next Page
Loading...
