ZyXEL Communications 1050 - Reports and Reboot; Report Commands Summary

ZyWALL (ZLD) CLI Reference Guide
251
CHAPTER 36
Reports and Reboot
This chapter provides information about the report associated commands and how to restart
the ZyWALL using commands.
36.1 Report Commands Summary
The following sections list the report and session commands.
36.1.1 Report Commands
This table lists the commands for reports.
Table 149 report Commands
COMMAND DESCRIPTION
[no] report Begins data collection. The no command stops
data collection.
show report status Displays whether or not the ZyWALL is collecting
data and how long it has collected data.
clear report [interface_name] Clears the report for the specified interface or for all
interfaces.
show report [interface_name {ip | service |
url}]
Displays the traffic report for the specified interface
and controls the format of the report. Formats are:
ip - traffic by IP address and direction
service - traffic by service and direction
url - hits by URL